Wood-mizer LT40L DH - Blade Alignment on Wheels; Blade Gullet Position and Cant Control Adjustment

Sawmill Alignment
Blade Installation And Alignment
Sawmill Alignment HDSdoc041118 5-4
5
(±1/16 [1.5 mm]). Do not let the teeth ride on the wheels.
To adjust where the blade travels on the idle-side blade wheel, use the cant control
shown in Figure 5-1.
If the blade is too far forward on the wheels, turn the cant control counterclockwise. If it is
too far back on the wheels, turn the cant control clockwise.
Some adjustment in blade tension may be needed to compensate for adjustments made
with the cant control.
Adjustment with the cant control is usually all that is required to track the blade properly
on both blade wheels. The drive-side blade wheel will usually not have to be adjusted.
If necessary, the drive-side wheel can be adjusted as follows:
FIG. 5-2
SM0044D
1 1/2"
Blade
± 1 mm (0.04”)
1 1/4"
Blade
3.0 mm (0.12”)
± 1 mm (0.04”)
4.5 mm (0.18”)