Sawmill Alignment
Adjusting Bed Rails To The Blade
5
5-11 HDSdoc041118 Sawmill Alignment
5. Move the saw head back to power the hydraulics and move the clamp so it is 10" from the
clamp stop. Move the saw head forward until it is positioned over the clamp. Raise the
saw head until the blade measures 15 5/16" (385 mm) from the clamp at its lowest
position.
6. Adjust the front pivot rail 90° to the main bed tube.
7. Move the saw head to center the blade over the front pivot bed rail.
8. Measure the distance from the top of the pivot rail to the bottom of the blade. Make this
measurement at each end of the pivot rail.
9. The two measurements should be 15" (375 mm) (+1/32 [0.8 mm] -0).
10. Loosen the locking set screws and turn the inner height adjustment nut to adjust the
height of the inner end of the pivot rail.
See Figure 5-8.
FIG. 5-8
To Next Page
Loading...
