Wood-mizer LT40L DH - Adjusting Bed Rails to Blade (Continued); Outer Pivot Rail Height Adjustment and Bed Rail Measurement

Sawmill Alignment
Adjusting Bed Rails To The Blade
Sawmill Alignment HDSdoc041118 5-12
5
See Figure 5-9. Optional bed rail (angled)
11. Loosen the jam nut and turn the outer adjustment bolt to adjust the height of the outer end
of the pivot rail.
12. Move the saw head so the blade is positioned over the center of the front main bed rail.
13. Measure the distance between the bottom of the blade and the bed rail at each end of the
bed rail. The bed rail should measure 15" (375 mm) (+1/32 [0.8 mm] -0) from the blade at
each end of the rail.
RYS. 5-9
Outer Height
Adjustment Bolt
to blade
to blade
Inner Height
Adjustment Nut