Wood-mizer LT40L DH - Adjusting Bed Rails to Blade (Continued); Bed Rail Clamping Bolt and Adjustment Procedures; Remaining Bed Rail Alignment

Sawmill Alignment
Adjusting Bed Rails To The Blade
5
5-13 HDSdoc041118 Sawmill Alignment
See Figure 5-10.
See Figure 5-11. Optional bed rail (angled)
14. Loosen the bed rail clamping bolts and turn the adjustment bolts to move the bed rails to
the blade if necessary.
15. Retighten the clamping bolts and adjustment bolts.
16. Without adjusting the saw head height, check the three remaining main bed rails and the
rear pivot rail. Adjust them so that all measure the same distance from the blade at both
ends of the bed rail.
FIG. 5-10
RYS. 5-11
SM0064_D
Blade
Bed rails
Clamp bolt
Clamp
Adjustment bolt
Adjustment bolt
Adjustment
bolt
bolt