Sawmill Alignment
Blade Guide Arm Vertical Adjustment
5
5-15 HDSdoc041118 Sawmill Alignment
6. The rollers are mounted on cam bolts that raise or lower the arm when turned.
To adjust the rollers, locate the cam bolt head inside the housing and turn until the arm is
lowered or raised as needed. Recheck the arm in both the open and closed positions.
Repeat adjustments until the arm is the same distance from the bed rail in the open and
closed position.
7. The blade guide arm should be snug, but not too tight, in the rollers. You should be able to
move it in and out with firm hand pressure. There should be no side-to-side play.
To Next Page
Loading...
