Wood-mizer LT40L DH - Blade Guide Arm Horizontal Adjustment; Assembly Reinstallation and Throat Closure; Guide Roller Adjustment Method

Sawmill Alignment
Blade Guide Arm Horizontal Adjustment
Sawmill Alignment HDSdoc041118 5-16
5
5.8 Blade Guide Arm Horizontal Adjustment
1. Put the blade guide assembly back in the arm (if you took it out). Put the assembly back
so that the flanged collar on the roller is about 1/8" (3.0 mm) from the back of the blade
when the throat is 1/2" (15 mm) from full open.
2. Close the throat to within 1/2" (15 mm) from fully closed. Check to see that the flange is
the same distance from the back of the blade.
See Figure 5-13.
3. If adjustment is needed, the guide rollers can be adjusted in or out on the threaded
mounts to open or close the gap.
FIG. 5-13
Flange equal
distance from
blade in open
and closed
positions
SM0067