Wood-mizer LT40L DH - Blade Guide Arm Horizontal Adjustment (Continued); Outside Roller Adjustment Effects and Equalization

Sawmill Alignment
Blade Guide Arm Horizontal Adjustment
5
5-17 HDSdoc041118 Sawmill Alignment
See Figure 5-14.
4. Adjusting the outside two rollers (furthest from the arm motor) inward will cause the flange
to move away from the blade.
5. Adjusting the two outside rollers outward will cause the flange to move toward the blade.
6. Adjust until the roller flange is the same distance from the back of the blade in the open
and closed position.
FIG. 5-14
Adjustment Nuts
Adjustment Nuts
SM0066