Wood-mizer LT40L DH - Blade Guide Vertical Tilt Adjustment (Continued); Carriage Movement and Measurement Repetition; Tilt Adjustment to Equal Measurements; Major Tilt Adjustment Impact

Sawmill Alignment
Blade Guide Vertical Tilt Adjustment
5
5-21 HDSdoc041118 Sawmill Alignment
See Figure 5-17.
8. Move the carriage forward so the back end of the tool is over the bed rail.
9. Use the set screws shown to adjust the blade guide tilt until the measurement from the
bed rail to the tool equals the other two measurements taken.
10. Move the tool close to the other blade guide and repeat the previous steps.
NOTE: If major adjustments to blade guide tilt were made, measure the distance between
the blade and the bed rails again to ensure the correct 1/4" (6.5 mm) blade guide
deflection. Adjust if necessary.
FIG. 5-17
SM0070
Loosen jam nuts and turn screws
to tilt roller up or down