Wood-mizer LT40L DH - Blade Guide Spacing Adjustment; Loosening Screws and Positioning Guides; Flange Spacing Measurement and Adjustment

Sawmill Alignment
Blade Guide Spacing
Sawmill Alignment HDSdoc041118 5-22
5
5.12 Blade Guide Spacing
HINT: When adjusting blade guide spacing, loosen the top set screw and one side set
screw only. This will ensure horizontal and vertical tilt adjustments are maintained when
the set screws are retightened.
1. Adjust the inner blade guide so the blade guide flange is approximately 3.0 mm) from the
back of the blade.
2. Loosen one side and one top set screw shown. Tap the blade guide forward or backward
until properly positioned.
See Figure 5-18.
3. Retighten the two set screws.
4. Adjust the outer blade guide in the same way so the blade guide flange is approximately
3.0 mm from the back of the blade.
FIG. 5-18
Loosen one top and
one side set screw
Adjust blade guide
to desired position
SM0071