Wood-mizer LT40L DH - Horizontal Tilt Adjustment; Arm Halving and Tool Placement; Measurement and Roller Parallelism; Side Set Screw Adjustment

Sawmill Alignment
Horizontal Tilt Adjustment
5
5-23 HDSdoc041118 Sawmill Alignment
5.13 Horizontal Tilt Adjustment
1. Finally, both blade guides must be tilted horizontally. Adjust the blade guide arm halfway
in.
See Figure 5-19.
2. Place the Blade Guide Alignment Tool against the face of the outer blade guide roller.
3. Center the tool on the roller and measure between the back edge of the blade and the
ruler at the end closest to the inner blade guide ("B").
4. Measure between the back edge of the blade and the other end of the ruler ("A").
5. The roller should be parallel to the blade (A=B) or tilted slightly to the left (A=B-1.4"
[6 mm]).
6. Use the side set screws to adjust the horizontal tilt of the roller.
7. Repeat steps 3-7 for the inner blade guide roller.
NOTE: Once the blade guides have been adjusted, any cutting variances are most likely
caused by the blade. See the Blade Handbook, Form #600.
FIG. 5-19
5
0
c
m
(
1
9
1
1
/
1
6
"
)