Sawmill Alignment
Vertical Adjustment of Side Supports
5
5-25 HDSdoc041118 Sawmill Alignment
5.15 Vertical Adjustment of Side Supports
1. Place a flat board across the bed rails.
2. Swing a side support up so that it is vertical.
3. Pull back at the top of the support to eliminate slack as if a log were being clamped
against it.
See Figure 5-21.
4. Check the angle of each support with a square on the board.
5. The side support should be 90° to the bed rails or leaning forward 1/32" (0.8 mm). Loosen
the top adjustment bolt, adjust the side support, and retighten the bolt.
6. Repeat for the remaining side supports.
FIG. 5-21
To Next Page
Loading...
