Sawmill Alignment
Clamp Stop/Stop Bolt Adjustment
Sawmill Alignment HDSdoc041118 5-26
5
5.16 Clamp Stop/Stop Bolt Adjustment
1. Once the side supports are aligned, pivot them down to their horizontal position.
2. Tie a string across the face of the side supports.
See Figure 5-22.
3. Loosen the clamp stop bolts and adjust the clamp stop until it touches the string. Loosen
the jam nut and adjust the bolt on the middle-rear bed rail until it touches the string.
FIG. 5-22
To Next Page
Loading...
