Safety & General Information
Sawmill Maintenance
1
1-7 doc041118 Safety & General Information
links.
CAUTION! Do not over-tension the up/down chain. Over-tensioning
may lead to early failure of the gear reducer.
CAUTION! Do not overtighten the feed chain. Damage to the power
feed motor may result.
CAUTION! Do not overtighten the contact set screws on the hydraulic
valve assembly. Overtightening may cause the threads in the screw
hole to strip.
CAUTION! Due to variations in the vertical mast, the pad spacing may
vary throughout the travel of the saw head. Check the pad spacing at
the top and bottom ends of the mast only. Pads adjusted too tight will
cause premature up/down motor failure.
CAUTION! It is important that the lower stop bolts are properly
adjusted to secure the carriage on the track rail. Failure to properly
adjust the stop bolts can cause saw head damage, especially during
mill transportation.
To Next Page
Loading...
