Safety & General Information
Dust Extractor Specifications
Safety & General Information doc041118 1-18
1
1.13 Dust Extractor Specifications
See Table 1-12. Specifications of the dust extractors used on the resaw for each saw head are
listed below.
1
IMPORTANT! The dust extractor hoses must be grounded or made
with materials not accumulating electrostatic charge.
CAUTION! Always turn on the dust extractor before starting the
machine
IMPORTANT! The total value of hand-arm vibration the operator may
be exposed to does not exceed 2.5 m/s
2
. The highest root mean
square value of weighted acceleration to which the whole operator’s
body is subjected does not exceed 0.5 m/s
2
.
Airflow
1200 m
3
/h
3937ft
3
/h
Inlet diameter 100 mm (5.9”)
Motor power 1,5 kW
Number of sacks 1 pcs
Sack capacity
0,25 m
3
(8.8 ft)
3
Weight 110 kg (242.5 lb)
Pressure drop
1,5 kPa (0.22 psi)
1
1
The pressure drop between the inlet of the capture device and
the connection to the CADES should be maximum 1,5 kPa
(for the nominal air flow rate). If the pressure drop exceeds
1,5 kPa the machine might not be compatible with conventional
CADES.
Recommended conveying air
velocity in the duct
20 m/s
65.6 ft/s
TABLE 1-12
1. External chip and dust extraction equipment with fixed installations are dealt with in EN
12779:2016-04.
To Next Page
Loading...
