Setup & Operation
Portable Sawmill Setup
Setup & Operation doc041118 2-4
2
2.3 Portable Sawmill Setup
WARNING! Do not set up the mill on ground with more than a 10
degree incline. If setup on an incline is necessary, put blocks under
one side of the mill or dig out areas for outrigger legs to keep mill level.
Setting up the mill on an incline could cause it to tip over, resulting in
serious personal injury.
WARNING! Chock the trailer wheels to prevent movement before
unhitching it from the towing vehicle. Failure to do so may result in
serious injury or death.
WARNING! Always make sure the trailer is supporting the sawmill
frame when operating a sawmill with adjustable outriggers. Failure to
do so may result in serious injury or death. The adjustable outriggers
are intended to support the saw frame with assistance from the trailer.
1. Unhitch the mill from the vehicle.
2. Lower and set the front three outriggers. To lower the leg, first place a 19 socket wrench on the
outrigger adjustment bolt and turn the bolt until the outrigger movable part reaches its highest
position. Next pull the locking pin out of the outrigger hole. When the outrigger contacts the ground,
release the pin. Then place a 19 socket wrench on the outrigger adjustment bolt and turn the bolt
until the locking pin enters the nearest outrigger hole.
WARNING! Put front outrigger down before moving cutting head from
the rest position. Failure to do so may result in serious injury.
To Next Page
Loading...
