Setup & Operation
Preparing The Sawmill For Towing
Setup & Operation doc041118 2-32
2
CAUTION! Move the hydraulic clamp and turner to provide maximum
ground clearance before towing. Failure to do so may result in damage
to the sawmill.
3. Move the carriage forward to the travel position over the rear bed rail.
4. Position the hole in the saw head over the travel rest pin.
5. Lower the saw head until it is seated firmly on the rest pin.
6. Secure the rest pin in the vertical position with the locking pin.
See Figure 2-17.
7. Continue lowering the head 19mm (3/4") until it contacts the stop blocks on the mast rails.
CAUTION! It is important that the lower stop bolts are properly
adjusted to secure the carriage on the track rail. Failure to properly
adjust the stop bolts can cause saw head damage, especially during
mill transportation.
8. If necessary, adjust the two stops located at the bottom of the mast so the saw head contacts them
after it is lowered 19mm (3/4") past where it contacts the rest pin.
FIG. 2-17
To Next Page
Loading...
