Wood-mizer LT40L DH - Blade Wheel Belts Maintenance; Belt Rotation, Wear Check, and Replacement

Maintenance
Blade Wheel Belts
3
3-7 HDSdoc041118 Maintenance
o-ring with the plug.
 Manually extend the rear piston (the front piston should remain extended).
 Use a small funnel or cup to completely fill the block with hydraulic fluid. When full,
place the fill plug in the fill plug hole and thread 1-2 turns. Manually push the rear
piston all the way in to allow excess oil and air to bleed from system through the
plug. Tighten the plug all the way.
 Reinstall the idle-side blade wheel, blade and blade housing covers. Reinstall the
tensioner ball and handle.
3.9 Blade Wheel Belts
1. Rotate the blade wheel belts and check them for wear. Rotating the belts every 50 hours
will give you longer belt life. Replace belts as necessary. Use only B57 belts
manufactured by Goodyear or Browning.
2. Periodically check all belts for wear. Replace any damaged or worn belts as needed.
3.10 Blade Wheel Belts
1. Rotate the blade wheel belts and check them for wear. Rotating the belts every 50 hours
will give you longer belt life. Replace belts as necessary. Use only B57 belts
manufactured by Goodyear or Browning.
2. Periodically check all belts for wear. Replace any damaged or worn belts as needed.
FIG. 3-4
Tension Handle and Ball
Front Piston
Piston Guide
Rear Piston
3H0610
Fill Plug
Gauge
50
50