Wood-mizer LT70HD - Default Chapter; Table of Contents

Table of Contents Section-Page
Table of Contents WMdoc072619 iii
TOC
SECTION 1 INTRODUCTION 1-1
1.1 About This Manual.................................................................................1-1
1.2 Getting Service .......................................................................................1-2
General Contact Information................................................1-2
Wood-Mizer Locations..........................................................1-3
1.3 Specifications .........................................................................................1-4
1.4 Customer and Sawmill Identification.....................................................1-5
1.5 Warranty .................................................................................................1-7
SECTION 2 SAFETY 2-1
2.1 Safety Symbols.......................................................................................2-1
2.2 Safety Instructions..................................................................................2-2
2.3 Electrical Lockout Procedures..............................................................2-12
SECTION 3 SAWMILL SETUP 3-1
3.1 Stationary Sawmill Setup .......................................................................3-1
3.2 Portable Sawmill Setup ..........................................................................3-8
3.3 Replacing The Blade ............................................................................3-14
3.4 Tensioning The Blade...........................................................................3-15
3.5 Tracking The Blade ..............................................................................3-16
3.6 Starting The Engine (or Motor)............................................................3-18
3.7 Board Return ........................................................................................3-19
3.8 Debarker Setup .....................................................................................3-21
SECTION 4 SAWMILL OPERATION 4-1
4.1 Hydraulic Control Operation (DCS) ......................................................4-1
4.2 Loading, Turning And Clamping Logs ..................................................4-5
4.3 Up/Down Operation (DCS)....................................................................4-7
4.4 Blade Guide Arm Operation (DCS) .......................................................4-8
4.5 Autoclutch Operation (DCS)..................................................................4-9
4.6 Power Feed Operation (DCS)...............................................................4-10
4.7 DCS Control Operation ........................................................................4-12
Display Overview................................................................4-12
Configuration ...................................................................4-14
Language ...................................................................4-15
Unit of Measure ..................................................................4-16
PID (Proportional - Integral - Differential) .......................4-16
Head Calibration ................................................................4-17
Engine Type ...................................................................4-18
Dashboard Settings .............................................................4-19
Auto Mode Settings .............................................................4-19
System Options ...................................................................4-20
Diagnostics ...................................................................4-21
Error Log ...................................................................4-21