Wood-mizer LT70HD - System Options

Sawmill Operation
System Options
Sawmill Operation 60HD-Rdoc072619 4-20
4
System Options
From the User Configuration menu, select the System Options menu and push the
CHECK button to enter. The System Options menu allows you to invert the joystick con-
trols if sawing from the rear of the machine, or to add/remove sawmill options. The
Hydraulic Offset option allows you to change the resolution of the proportional hydraulic
functions. To change any of the settings, use the UP/DOWN arrows at the bottom to
select the desired setting. Use the side UP/DOWN buttons to change the setting as nec-
essary. Push the SAVE button to save the changes and exit.
See Figure 4-16.
FIG. 4-16
D
C
S
D
C
S
istributed
ontrol
ystem
istributed
ontrol
ystem
600337-6
System Options
Debarker Installed: Yes
Log Deck Installed: No
Laser Inactivity Timeout: 120 sec
Hydraulic Offset: 82 %
Pull-Down Clamps: None
Laser Installed: Yes
Push SAVE
button to save
changes and exit
Push UP/DOWN
button to
change setting
Push UP or DOWN
arrow to choose setting
Invert Joystick Controls: No