Wood-mizer LX150 - Page 11

Installation
Install the motor harnesses
Installation 12/19/19 1-11
1
a. Thread the cable end with the two boots through the straight arm and the pivot
arm, similar to the strobe light wire. See Fig.
b. Place the ring terminals on the motor -- red to positive, black to negative.
c. Replace the terminal nuts removed in step 5.
NOTICE: Ring terminals must not touch the motor.
d. Slide the rubber boots over the motor terminal studs.
11. Replace the motor cap.
12. Use wire ties as necessary to bundle the cables neatly.
FIG. 1-8
3H1148-13
+
Cutter motor cable
Strobe light cable