Installation
Control box harness installation
1-18 12/19/19 Installation
1
11. Connect the 90” cutter motor cable red wire to the solenoid terminal 2 and the black wire
to the alternator ground bolt.
12. Reinstall terminal nuts and slide the boots on the terminal. Tightened alternator ground
bolt.
13. Check all nuts for tightness and secure protective boots over terminals.
1.5 Control box harness installation
1. Remove the front panel (leave wires connected) from the control box.
2. Cut out debarker on/off and in/out switch holes in the front panel decal.
FIG. 1-15
Terminal 2
VIEWED FROM BOTTOM-RIGHT
TO SHOW ALL CONNECTIONS
Alternator ground bolt
Cutter motor harness
To Next Page
Loading...
