Wood-mizer LX150 - Alignment; Align the Debarker to the Sawblade; Horizontal Alignment

Alignment
Align the Debarker to the Sawblade
1
1-22 WM doc 12/19/19 Alignment
SECTION 1 ALIGNMENT
1.1 Align the Debarker to the Sawblade
Horizontal Alignment
1. Turn the power key to ACC (3) and use the debarker in/out switch to move the debarker
completely inward.
WARNING! Turn the base unit’s power to OFF, remove the key, and
disconnect the battery ground terminal, if applicable.
2. Clip the blade guide alignment tool (or an appropriate straight edge) to the sawmill blade.
NOTE: Ensure the tool lies flat on the blade and does not contact a
tooth or burr.
3. Check the squareness of the debarker with the sawmill blade.
a. Mark the position of the debarker blade in relationship to the bottom of the blade
guide alignment tool. (Measurement A in Fig. 1-1.)
b. Turn the key to ACC (3) and use the debarker in/out switch to move the debarker
all the way inward.
WARNING! Turn the base unit’s power to OFF, remove the key, and
disconnect the battery ground terminal, if applicable.
c. Mark the position of the debarker blade in relationship to the bottom of the blade
guide alignment tool. (Measurement B in Fig 1-1.)