Wood-mizer LX150 - Vertical Alignment

Alignment
Vertical Alignment
Alignment WM doc 12/19/19 1-25
1
Vertical Alignment
1. Loosen the four blade motor mount bolts. See Fig. 1-3.
2. Loosen the jam nuts on the adjustment bolts.
3. Turn the adjustment bolt to position the motor with blade up or down.
4. Retighten the adjustment bolt jam nut and four motor mount bolts.
5. Recheck that the debarker blade has remained parallel with the sawblade.
6. Repeat the adjustment steps until the debarker blade is both centered on the bottom of
the blade guide adjustment tool and parallel to the sawmill blade.
FIG. 1-3
3H1146-9
Vertical Adjustment Bolts
Jam nuts
Motor Mount
Bolts
Sawblade
Blade Guide
Alignment Tool
Debarker blade
The bottom of the blade guide alignment tool should align with the center of the debarker blade.