Wood-mizer LX150 - Assemble Debarker; Assemble Mounting Plate

Installation
Assemble Debarker
1-6 12/19/19 Installation
1
1.2 Assemble Debarker
Assemble Mounting Plate
1. Tighten the hardware holding the mounting plate on the debarker arm. See Figure 1.
2. Remove wire harness clamp hardware from the mounting hole on the sawhead.
3. Align the debarker hardware into the mounting holes. See Figure1-2.
FIG. 1-1
FIG. 1-2
LX15049-1
Bolt,
1/2-13x1
Washer,
1/2 Lock
Washer,
1/2 Flat
Mounting Plate
LX15049-2
Nut, Nyloc
3/8-16
Washer,
3/8 Flat
Washer,
3/8 Lock
Washer,
3/8 Flat
Washer,
3/8 Flat
Bolt,
3/8-16X3 1/2 HH Gr5
Bolt,
3/8-16X 5/8 Gr5
Shim
Mounting
Bracket