Wood-mizer LX150 - Mount the Cutter Motor; Install the Motor Harnesses

Installation
Mount the Cutter Motor
1-8 12/19/19 Installation
1
Mount the Cutter Motor
1. Install the cutter head to the pivot arm mounting bracket. See Fig. 1-4.
1.3 Install the motor harnesses
NOTICE: Avoid pinch and pivot points, unnecessary wire bending, and
open spaces where the wire could get caught by a log, etc.
1. Unclip the strobe light wire coming out of the debarker arm and thread it through the
starred grommet from the hardware bag.
FIG. 1-4
LX15049-4
Bolt,
3/8-16X 5/8 Gr5
Washer,
3/8 Flat
Washer,
3/8 Lock