Sawmill Assembly
Saw Mast Assembly
Sawmill Assembly WMdoc041521 3-13
3
See Figure 3-12.
6. Repeat the bed rail adjustment with the string at the other side of the sawmill frame.
3.4 Saw Mast Assembly
IMPORTANT! Do not attempt to set the carriage down on any surface
that is not properly supported. Equipment damage will occur.
1. Check the orientation of the carriage before placing it on the bed frame; the operator is on
the same side as the log supports.
2. Position the saw head over the end of the bed frame assembly.
3. Carefully slide the saw head rollers onto the bed frame track, keeping the saw head
square to the bed to avoid jamming the track rollers.
4. Lower the saw head on the bed frame.
5. Mount the mast safety assembly to each track roller housing (one on the power feed side
and two on the idle side).
FIG. 3-12
Matching
Spacer
Matching
Spacer
String
Measure the distance between
the string and the bed rails
To Next Page
Loading...
