Sawmill Assembly
Feed Drive Rope Assembly
Sawmill Assembly WMdoc041521 3-15
3
See Figure 3-15.
8. Fill the water and fuel tank.
3.5 Feed Drive Rope Assembly
1. Thread one end of the feed rope through the bumper bracket at the front end of the bed
assembly.
2. Slide one F05011-44 fender washer over the outside end of the rope.
3. Tie a knot in the rope at that end as shown in Figure 3-16.
See Figure 3-16.
4. Thread the feed rope through the pulleys of the feed drive assembly in a figure 8 pattern
as shown in Figure
3-17.
FIG. 3-15
FIG. 3-16
Fuel input line
Return line
To Next Page
Loading...
