Sawmill Assembly
Feed Drive Rope Assembly
3
3-16 WMdoc041521 Sawmill Assembly
NOTE: The pulleys may be difficult to access, but it is not necessary to
remove any parts.
See Figure 3-17.
5. Assemble the feed rope eyebolt in the rear bumper bracket as shown in Figure 3-18.
6. Thread the feed rope through the rope lock plate, the eyebolt, and back through the plate
as shown in Figure
3-18.
7. Tie a knot in the end of the feed rope.
8. Adjust the feed rope tension by sliding the rope lock plate.
See Figure 3-18.
FIG. 3-17
FIG. 3-18
Pulleys are located
between the bed
frame feed drive
motor
To Next Page
Loading...
