Sawmill Assembly
Install the Blade
3
3-18 WMdoc041521 Sawmill Assembly
See Figure 3-19.
5. Carefully remove and uncoil the blade from the shipping box.
6. Place the new blade around the blade wheels.
NOTE: When installing a blade, make sure the teeth are pointing the
correct direction. The teeth should be pointing toward the operator side
of the mill when you are looking at the blade below the blade guides. If
necessary, invert the blade as shown in the video.
7. Position 1 1/4” wide blades (standard) on the wheels so the gullet is 1/8" (3.0 mm) out
from the edge of the wheel.
FIG. 3-19
Tensioner handle
Tensioner handle
(storage area)
To Next Page
Loading...
