Wood-mizer LX150 - Page 42

Sawmill Setup
Tracking The Blade
4
4-5 WMdoc122320 Sawmill Setup
See Figure 4-4.
7. Position 1 1/4” wide blades so the gullet is 1/8" (3.0 mm) out from the edge of the blade
wheel (±1/32 [.75 mm]).
See Figure 4-5.
8. Adjust the blade tension if necessary to compensate for any changes that may have
occurred while adjusting the cant control.
9. Close the blade housing covers an ensure blade housing and pulley covers are in place
and secure
FIG. 4-4
FIG. 4-5
LX1501-07
Cant Control
150060
1/8” (3.0 mm)
± 1/32” (0.75 mm)
1 1/4”
Blade