Sawmill Alignment
Blade Guide Arm Alignment
8
8-4 WMdoc041521 Sawmill Alignment
See Figure 8-3.
12. Adjust the blade guide arm until the two measurements are the same.
NOTE: Start with the upper/lower roller assemblies on one side and
move to the other if necessary.
Multiple trials may be needed to obtain the proper alignment.
a. Loosen (do not remove) the nut inside the sawhead frame.
b. Adjust the roller assembly bolt (loosen/tighten as necessary) on the end of the
roller assembly.
c. Move the rollers the appropriate distance in or out until the measurements are the
same.
d. Tighten the nut inside the sawhead.
See Figure 8-4.
FIG. 8-3
FIG. 8-4
a. Loosen
b. Adjust
ROLLER ASSEMBLY
c. Tighten
To Next Page
Loading...
