Sawmill Alignment
Blade Guide Arm Alignment
Sawmill Alignment WMdoc041521 8-17
8
See Figure 8-16. Sawhead frame members remove for illustration purposes only.
BLADE GUIDE ARM HORIZONTALLY (PARALLEL TO THE BLADE)
9. Fully extend the blade guide arm. See Fig.8-1.
10. Measure the distance between the blade and the blade guide arm near the blade guide.
11. Measure the distance between the blade and the blade guide arm near the sawhead
frame.
See Figure 8-17.
12. Adjust the blade guide arm until the two measurements are the same.
NOTE: Start with the upper/lower roller assemblies on one side and
move to the other if necessary.
Multiple trials may be needed to obtain the proper alignment.
FIG. 8-16
FIG. 8-17
b. Loosen
a. Loosen
c. Adjust
ROLLER ASSEMBLY
d. Tighten
e. Tighten
To Next Page
Loading...
