Wood-mizer LX25 - Level the bed

Setup
Assemble the bed sections
3
Setup WM doc 12/21/223-7
2. Assemble the remaining track rails and cross rail in a similar fashion. See FIG. 3-2.
3. Connect the bed sections using a connecting plate, a clamp, and hardware.
a. Attach the connecting plate (X100-934) to each bed section, joining them together.
b. Tighten the side of the plate that has the fixed holes. Do not fully tighten the bolts (M10-1.5x30) on the side of
the plate that has slotted holes.
c. Set the clamp in place by inserting the larger notch first (on bottom) and then tilting the clamp in and upward
to catch the smaller notch (on top). See FIG. 3-3.
d. Tighten the bolts on the clamp (M10-1.5x85) to draw bed sections together.
NOTE: Be sure the track rails of each bed section are aligned before tightening the
plate bolts.
FIG. 3-3
TDLX2503-02
Direction of cut
FIG. 3-2
T100001-3
Smaller Notch
Larger Notch
Fixed Holes
Slotted Holes
Plate Bolts
Connecting Plate
Clamp
Bolt, M10-1.5x85, HH,
Class 8
Washer, M10 Flat
Nut, M10-1.5 Flanged
Nylon Lock
Washer, M10 Flat
Nut, M10-1.5
Flanged Nylon Lock