Wood-mizer LX25 - Install the Mast

Setup
Install the mast
3
Setup WM doc 12/21/223-9
4. When the bed is leveled, square up the log rest posts.
Tighten the log rest bracket screws. See FIG. 3-7.
5. Recheck saw bed for level!
3.4 Install the mast
Prepare the mast carriages
The sawhead carriages come mostly assembled from the
factory.
1. Place 4 carriage bolts from the hardware kit through
the inner side of the carriage.
2. Place washers and nuts loosely on the M10-1.5x70
carriage bolts.
See FIG. 1-8.
NOTE: Do not tighten them at
this time.
3. Set the carriage on the rails.
NOTE: There is a bearing
for each side of the rail, and
the carriage rests on the
vertical bearing. The side
bearings are adjustable (slot-
ted holes), and must be
adjusted at this time. The ver-
tical bearings are not adjust-
able.
See FIG. 3-9.
4. Adjust the bearings now so that the carriage glides
smoothly back and forth with little effort.
5. Repeat on the opposite side of the saw bed.
6. Remove the carriages from the rails for further installation with the mast.
1
0
0
B
-
0
0
2
Square
Log Rest Post
Log Rest Bracket
FIG. 3-7
T10003-6
Bolt, M10-1.5x70
Carriage
Washer, M10 Flat
Nut, M10-1.5 Hex
FIG. 3-8
Vertical Bearings
(highlighted green)
Rail
FIG. 3-9
Side Bearings
(highlighted red)