Wood-mizer LX25 - Assemble the Up;Down Crank

Setup
Assemble the up/down crank
3
3-16 WM doc 12/21/22Setup
6. Tighten the clutch cable in the bracket with a wrench.
See FIG. 3-28.
NOTE: The throttle should be
adjusted after the LX25 is fully
assembled and ready for use.
NOTE: The clutch cable can
also be adjusted at the
clutch or at the engine. See
FIG. 3-29.
3.10 Assemble the up/down crank
1. Bolt on the crank handle.
NOTE: Make sure that the
lock washer is in place
between the flat washer and
bolt head as shown. See FIG. 3-30.
FIG. 3-30
Bolt, M6-1x70 HHB
Nut, M6 8 FE/ZN5
PN-85/M-82144
Cable Eye
Nut, M6-1.0 Nylon
Lock
FIG. 3-28
100B-016
FIG. 3-29
Lock washer
Nut, M12-1.75 Zinc Jam
Crank Handle
Nut, M12x1.75 Free Znc
Bolt, M12-1.75x120
SHC