Setup
Install the dust chute
3
3-18 WM doc 12/21/22Setup
3.12 Install the dust chute
Fasten the dust chute to the sawhead with the three M6-1 x
14 Class 8 bolts and nuts provided in the hardware kit. See
FIG. 3-33.
3.13 Install the Blade
WARNING!Wear gloves and eye protection when handling bandsaw blades. Fail-
ure to follow this may result in serious injury.
Keep all other persons away from area when coiling, carrying, or changing a blade.
Changing blades is safest when done by one person. Failure to follow this may
result in serious injury.
NOTE: Do not remove the blade from the shipping box at this time.
1. Go to:
2. Open the blade housing cover.
3. Carefully remove and uncoil the blade from the shipping box.
Bolt, M6-1 x 14 Class 8
Washer, M6 Split Lock
Washer, M6 Flat Class 4
FIG. 3-33
DANGER! COILED BLADES ARE UNDER
SPRING TENSION. KNOW PROPER
BLADE HANDLING BEFORE UNPACKING
YOUR BLADE. FAILURE TO FOLLOW THIS
WILL RESULT IN SERIOUS INJURY.
READ THE PAMPHLET THAT CAME WITH YOUR MILL OR WATCH THE VIDEO
ON SAWMILL BLADES BEFORE REMOVING THE BLADE FROM THE BOX.
HOW TO COIL, UNCOIL, AND
INVERT A BLADE
https://www.youtube.com/watch?v=43TWwSgSOaQ
To Next Page
Loading...
