Setup
Install the lube water tank
3
3-20 WM doc 12/21/22Setup
3.14 Install the lube water tank
NOTE: Before install-
ing the water tank,
check for blade
straightness. See
"Blade straightness."
In order to loosen the
guide block, the water
tank must be
removed.
1. Fasten the lube water tank to the sawhead
with the four M6-1x12 bolts and nuts provided
in the hardware kit.
2. Thread the lube water tube through the grom-
met next to the right blade guide. . See FIG.
3-35.
Water Lube
Tank
Washer, 1/4 Flat
Water Lube Tube
Grommet
Nut, M6-1.0 Nylon
Lock
Bolt, M6-1x12
FIG. 3-35
To Next Page
Loading...
