Wood-mizer LX25 - Page 28

Setup
Install the Blade
3
3-18 LX25 8/25/21 Setup
5. Place the new blade around the blade wheels and through the blade guides. (See FIG. 3-28 .).
NOTE: When installing a blade, make sure the teeth are pointing t toward the dust
chute. If necessary, invert the blade as shown in the video.
6. Position 1 1/4” wide blades on the wheels so the gullet is 1/8" (3.0 mm) out from the edge of the wheel. (See FIG. 3-29 .).
Go directly to the Section 4, Sawmill adjustments to align it before use.
FIG. 3-28
FIG. 3-29
55001-38
150060
1/8” (3.0 mm)
± 1/32” (0.75 mm)
1 1/4”
Blade