SAWMILL ASSEMBLY
Bed Frame Assembly
SAWMILL ASSEMBLY 15doc032021 2-9
2
2.3 Bed Frame Assembly
IMPORTANT! When assembling the sawmill, do not tighten the
bolts/screws too much at the begining. The fasteners should be tight-
ened fully only when all parts are already mounted.
CAUTION! Assemble the sawmill bed on firm, level ground. Failure
to do so may cause the saw head to tip, resulting in serious injury or
death.
1. Place the track rails on level ground. Attach them to the cross rails using the M10x30 bolts. Repeat
it for all bed segments.
See figure 2-3.
2. Position all three assembled bed sections end-to-end in the order shown on the figure 2-4.
See figure 2-4.
FIG. 2-3
FIG. 2-4
Direction of Cut
Bed Section
To Next Page
Loading...
