SAWMILL ASSEMBLY
Stop Blocks Installation
2
2-12 15doc032021 SAWMILL ASSEMBLY
2.5 Stop Blocks Installation
1. Install the stop blocks at both ends of the bed to prevent the saw head from sliding off the bed.
Attach the stop blocks on the outside surfaces of the front and last bed sections. Use M10x30
bolts.
The stop blocks can also be used to prevent accidental saw head movement - see Section 2.7 Saw
Head Installation, step 5.
WARNING! Failure to do so may result in serious personal injury or machine damage.
See figure 2-8.
FIG. 2-8
To Next Page
Loading...
