Sawmill Operation
Tracking the Blade
3
3-5 doc072221 Sawmill Operation
3.5 Tracking the Blade
After tensioning the blade, check its position on the blade wheels.
See Figure 3-2. Position 1 1/4” (32 mm) wide blades on the blade wheels so the blade teeth are
9 -10 mm (±1 mm) out from the edge of the wheel. Make sure the rear edge of the blade is lying flat
on the wheels and is no more than 3 mm out from the edges of the blade wheel belts.
To track the blade properly on both blade wheels:
(CE electric version) - open the blade housing cover, set the key switch to the "H" position
and spin the blade wheel by hand a few times.
(Non-CE electric version) - open the blade housing cover and spin the blade wheel by hand
a few times.
(Gas engine version) - open the blade housing cover and spin the blade wheel by hand a few
times.
Two cant control bolts are located at the rear of the saw head, on both sides.
FIG. 3-2
To Next Page
Loading...
