Wood-mizer LX50 G14S - Page 86

Sawmill Operation
Blade Guide Spacing Adjustment
3
3-17 doc072221 Sawmill Operation
See Figure 3-14.
3. Tighten the set screws.
4. Repeat the above adjustment procedure for the other blade guide.
NOTE: After adjusting the blade guide spacing, start the blade drive for a moment. Then stop the
blade and recheck the spacing.
FIG. 3-14
SM0071a
1,5 - 3,0 mm
Loosen one top and
one side set screw
Adjust spacing between
roller and blade