Safety
Keep Work Area Clean
Safety LX55 9/17/20 2-3
2
Keep Work Area Clean
Clean sawdust from all guards, vents, control boxes, or any area where
sawdust may gather after every shift. Failure to do so may result in fire,
causing death or serious injury
Maintain a clean and clear path for all necessary movement around the
equipment and lumber stacks.
NOTICE Always properly dispose of all sawing by-products, includ-
ing sawdust and wood debris, coolant, oil, fuel, oil filters, and fuel filters.
If replacing a component which has a safety decal affixed to it, make sure
the new component also has the safety decal affixed.
Inspect all safety decals to ensure they are clean and readable. Replace
all damaged safety decals to prevent personal injury or damage to the
equipment. Contact your local distributor, or call your Customer Service
Representative to order more decals.
Fuel/Flammable Liquid Handling Safety
Do not smoke, weld, grind, or otherwise create sparks near your engine or
storage tanks, especially during times of fueling.
Do not allow fuel/flammable liquid to spill on a heat source, such as a hot
engine.
Store gasoline away from sawdust and other flammable
materials.
Do not use flammable liquids (diesel fuel or kerosene) in
the water lube accessories.
Clean fuel/flammable liquid spills immediately.
NOTICE Remove blades from equipment before cleaning them with
fuel/flammable liquid.
Dispose of fuel/flammable liquids per local ordinances.
To Next Page
Loading...
