Assembly
Unpack the Mill
Assembly LX55 9/17/20 3-1
3
SECTION 3 ASSEMBLY
3.1 Unpack the Mill
Parts are shipped according to size, not according to assembly.
NOTICE The sawhead is held upright by the bed cross rail
bolted to the crate end. Be prepared to support the sawhead
when the cross rail is unbolted.
1. Remove and unwrap all sawmill parts.
2. Set them where they are all visible.
3. Place the sawhead on a bench/flat surface at least 24” (0.6m) off the ground.
4. Open the small parts box -- not the blade box.
3.2 Site Preparation
Assemble the mill at its permanent site.
Ensure ground is firm and level.
Clear the area.
Inspect the site for debris or uneven surfaces that may become a trip hazard.
Clear out all non-essential personnel.
Gas mills
Do not set up in enclose areas.
CAREFUL PLANNING IS ESSENTIAL TO A
SMOOTH ASSEMBLY.
READ THIS SECTION THOROUGHLY TO
PLAN THE ASSEMBLY.
DANGER! COILED BLADES ARE UNDER
SPRING TENSION. KNOW PROPER
BLADE HANDLING BEFORE UNPACK-
ING YOUR BLADE. FAILURE TO FOLLOW THIS
WILL RESULT IN SERIOUS INJURY.
Do not unpack the blade until ready for installation.
To Next Page
Loading...
