Assembly
Stop Blocks Installation
3
3-8 LX55 9/17/20 Assembly
5. Attach the complete log clamp in the middle of the bed using the M10x30mm bolts. See Fig. 3-9.
6. Assemble the second log clamp near the end of the log bed. See Fig. 3-9.
Stop Blocks Installation
1. Install the stop blocks (ib Bed Kit bag) at both ends on the operator’s side to prevent the saw-
head from sliding off the bed. See Fig. 3-10.
2. Attach the stop blocks on the outside surfaces of the front and last bed sections using
M10x30mm bolts.
NOTE: The stop blocks can also be used to prevent accidental sawhead
movement as described in Secure the Sawhead Carriage
.
Failure to install stop blocks may result in serious personal injury and/or
machine damage.
FIG. 3-9
FIG. 3-10
Bolt, M10x30mm,
Class 8
Washer, M10 Flat
Nut, M10 Flanged
Nylon Lock
Side Support
against tab
Bolt, M10x30mm,
Class 8
Securing pin
Nut, M10 Flanged
Nylon Lock
Washer, M10 Flat
To Next Page
Loading...
