Assembly
Assemble Catch Rail
3
3-10 LX55 9/17/20 Assembly
NOTE: If the carriage does not ride smoothly, recheck how the bearings sit
on the rail.
4. Align the horizontal bearings. See Fig. 3-12.
a. Move the horizontal bearings against the track rail lightly touching the bearings and the
vertical surface of the track rail while the sawhead is being moving.
b. Tighten the nuts to lock the bearings in the adjusted position.
NOTE: If the bearings press too firmly against the rail, it will impede move-
ment on the rail resulting in premature bearing wear.
c. Make this adjustment for all horizontal bearings (4 on each roller).
5. Install the felt pad (from Bed Kit bag) on the track wiper bracket.
6. Adjust the track wiper so that the felt touches the track rail surface and the sawhead moves freely
on the bed. See Fig. 3-13.
Assemble Catch Rail
The catch rail may be assembled on either side, but installing on the dust chute side makes load-
ing logs easier.
FIG. 3-13
To Next Page
Loading...
