Wood-mizer LX55 - Default Chapter; Table of Contents

Table of Contents Section-Page
Table of Contents LX55 9/17/20 iii
INTRODUCTION
1.1 About This Manual.................................................................................1-1
1.2 Getting Service .......................................................................................1-1
General Contact Information................................................1-1
1.3 Warranty .................................................................................................1-2
1.4 Customer and Sawmill Identification.....................................................1-5
1.5 LX55 Specifications ...............................................................................1-6
SAFETY
2.1 Safety Symbols.......................................................................................2-1
2.2 Safety Instructions..................................................................................2-1
Observe ALL Safety Instructions...........................................2-1
Wear Safety Clothing (Personal Protection Equipment)...... 2-2
Keep Work Area Clean .........................................................2-3
Fuel/Flammable Liquid Handling Safety..............................2-3
Battery Safety ........................................................................2-4
Sawmill Setup Safety .............................................................2-5
2.3 Safety Decals..........................................................................................2-6
ASSEMBLY
3.1 Unpack the Mill......................................................................................3-1
3.2 Site Preparation ......................................................................................3-1
3.3 Torque Settings.......................................................................................3-2
3.4 Sawhead Installation...............................................................................3-2
3.5 Assemble the Log Bed............................................................................3-4
Assemble the bed sections .....................................................3-5
Assemble the connector plates ..............................................3-6
Assemble the log clamps .......................................................3-7
Stop Blocks Installation ........................................................3-8
Bed leveling .........................................................................3-9
3.6 Carriage Placement.................................................................................3-9
Assemble Catch Rail ...........................................................3-10
Secure the Sawhead Carriage.............................................3-11
3.7 Tension Tool, Latch, and Sawdust Chute Assembly............................3-12
3.8 Install the Engine (Gas Versions Only)................................................3-12
3.9 Install the Motor (Electric Version Only) ...........................................3-15
3.10 Finish Carriage Assembly ....................................................................3-17
Push Handle .......................................................................3-18
Mount Lift System................................................................3-19
3.11 Clutch Lever Installation (Gas versions only)......................................3-25
3.12 Water Bottle Installation.......................................................................3-26