Wood-mizer LX55 - Install the Engine (Gas Versions Only)

Assembly
Tension Tool, Latch, and Sawdust Chute Assembly
3
3-12 LX55 9/17/20 Assembly
3.7 Tension Tool, Latch, and Sawdust Chute Assembly
1. Install the tension tool (ratchet) on the rear of the sawhead. See Fig. 3-16.
2. Install the sawhead cover latch using two M8x25mm cap screws. See Fig. 3-17.
3. Open the sawhead cover and fasten the sawdust chute using the M6x16mm bolts. See Fig. 3-17.
3.8 Install the Engine (Gas Versions Only)
1. Unpack the engine and its parts.
2. Set the engine on the engine mounting platform and loosely secure with M10x50mm bolts. See
Fig. 3-18.
FIG. 3-16
FIG. 3-17
55001-34
Mounting stud
Wing nut, M10
Washer, M10 Flat
55001-27
Bolt, M6x16mm
Cap screws, M8x25mm
Washer, M8 Flat
Washer, M8 Split
Nut, M6 Nylon Lock
Washer, M8 Flat