Wood-mizer LX55 - Page 31

Assembly
Install the Engine (Gas Versions Only)
Assembly LX55 9/17/20 3-13
3
3. Replace the existing cable bracket on the engine with the supplied cable bracket. See Fig. 3-18.
4. Loosely attach the throttle cable to the cable bracket. See Fig. 3-19.
5. Insert the throttle fitting in the throttle lever bracket. See Fig. 3-19.
6. Insert the shaft key and the large bushing over the engine shaft. See Fig. 3-20.
NOTE: If the shaft key is too tight, file to fit.
7. Ensure the bushing is flush to the end of the shaft. See Fig. 3-20.
8. Tighten the bushing set screw with a 3mm hex wrench. See Fig. 3-20.
9. Set the pulley over the bushing.
FIG. 3-18
FIG. 3-19
55007-2
Bolts, M10x50mm
Cable mounting bracket
Washer, M10 Flat
Nut, M10 Hex Nylon Lock
55007-3
Throttle fitting
Throttle cable,
loosely secured
Throttle lever
Cable bracket