Wood-mizer LX55 - Mount Lift System

Assembly
Mount Lift System
Assembly LX55 9/17/20 3-19
3
Mount Lift System
INSTALL BRACKETS
1. Insert the bronze bushings into the holes located on up/down brackets. See Fig. 3-27.
2. Use M8x30mm and M8x75mm bolts to install the lift bracket near the control box.
3. Slide the large sprocket onto the shaft. See Fig. 3-29.
4. Slide shaft into the bushings on the brackets, ensuring the key slot of the shaft is on the oper-
ator’s side.
ASSEMBLE SPROCKET ON SHAFT
1. Align the key in the slot in the shaft.See Fig. 3-29.
2. Align the sprocket keyway over the key.
3. Tighten the sprocket set screw. (See inset of Fig. 3-29.)
4. Attach the shaft ends.
NOTICE The helical shaft ends are left-right oriented according to
the direction of the spiral. Ensure that the spiral directs the lift cable to the
FIG. 3-27
55001-21-2
Bolts, M8 x 30mm
Bushing -
flange on the outside
Bolts, M8 x 75mm
Bushing -
flange on the outside
Bushing -
flange on the inside
Nut, M8 Flanged
Nylon Lock
Washer, M8 Flat
Lift bracket